第 30 章 Configuring IPsec VPN connections by using RHEL system roles

Procedure

1. Create a playbook file, for example, ~/playbook.yml, with the following content:

   ---
   - name: Configuring VPN
     hosts: managed-node-01.example.com, managed-node-02.example.com
     tasks:
       - name: IPsec VPN with PSK authentication
         ansible.builtin.include_role:
           name: redhat.rhel_system_roles.vpn
         vars:
           vpn_connections:
             - hosts:
                 managed-node-01.example.com:
                 managed-node-02.example.com:
               auth_method: psk
               auto: start
           vpn_manage_firewall: true
           vpn_manage_selinux: true

   The settings specified in the example playbook include the following:

   hosts: <list>

   Defines a YAML dictionary with the peers between which you want to configure a VPN. If an entry is not an Ansible managed node, you must specify its fully-qualified domain name (FQDN) or IP address in the hostname parameter, for example:

             ...
             - hosts:
                 ...
                 external-host.example.com:
                   hostname: 192.0.2.1

   The role configures the VPN connection on each managed node. The connections are named <peer_A>-to-<peer_B>, for example, managed-node-01.example.com-to-managed-node-02.example.com. Note that the role cannot configure Libreswan on external (unmanaged) nodes. You must manually create the configuration on these peers.

   auth_method: psk

   Enables PSK authentication between the peers. The role uses openssl on the control node to create the PSK.

   auto: <startup_method>

   Specifies the startup method of the connection. Valid values are add, ondemand, start, and ignore. For details, see the ipsec.conf(5) man page on a system with Libreswan installed. The default value of this variable is null, which means no automatic startup operation.

   vpn_manage_firewall: true

   Defines that the role opens the required ports in the firewalld service on the managed nodes.

   vpn_manage_selinux: true

   Defines that the role sets the required SELinux port type on the IPsec ports.

   For details about all variables used in the playbook, see the /usr/share/ansible/roles/rhel-system-roles.vpn/README.md file on the control node.

2. Validate the playbook syntax:

   $ ansible-playbook --syntax-check ~/playbook.yml

   Note that this command only validates the syntax and does not protect against a wrong but valid configuration.

3. Run the playbook:

   $ ansible-playbook ~/playbook.yml