6.4.2. Adding a node with command flags

Procedure

1. Generate the ISO image by running the following command. The MAC address must be specified using a command flag. See the "Cluster configuration reference" section for more flags that you can use with this command.

   $ oc adm node-image create --mac-address=<mac_address>

   where:

   <mac_address>

   Specifies the MAC address of the node that is being added.

   重要

   In order for the create command to fetch a release image that matches the target cluster version, you must specify a valid pull secret. You can specify the pull secret either by using the --registry-config flag or by setting the REGISTRY_AUTH_FILE environment variable beforehand.

   提示

   To see additional flags that can be used to configure your node, run the following oc adm node-image create --help command.

2. Verify that a new node.<arch>.iso file is present in the asset directory. The asset directory is your current directory, unless you specified a different one when creating the ISO image.
3. Boot the node with the generated ISO image.

4. Track progress of the node creation by running the following command:

   $ oc adm node-image monitor --ip-addresses <ip_address>

   where:

   <ip_address>

   Specifies a list of the IP addresses of the nodes that are being added.

   注意

   If reverse DNS entries are not available for your node, the oc adm node-image monitor command skips checks for pending certificate signing requests (CSRs). If these checks are skipped, you must manually check for CSRs by running the oc get csr command.

5. Approve the pending CSRs by running the following command for each CSR:

   $ oc adm certificate approve <csr_name>