Dieser Inhalt ist in der von Ihnen ausgewählten Sprache nicht verfügbar.
Chapter 12. Services and Daemons
Maintaining security on your system is extremely important, and one approach for this task is to manage access to system services carefully. Your system may need to provide open access to particular services (for example,
httpd if you are running a web server). However, if you do not need to provide a service, you should turn it off to minimize your exposure to possible bug exploits.
This chapter explains the concept of runlevels, and describes how to set the default one. It also covers the setup of the services to be run in each of these runlevels, and provides information on how to start, stop, and restart the services on the command line using the service command.
Important
When you allow access for new services, always remember that both the firewall and SELinux need to be configured as well. One of the most common mistakes committed when configuring a new service is neglecting to implement the necessary firewall configuration and SELinux policies to allow access for it. For more information, see the Red Hat Enterprise Linux 6 Security Guide.
12.1. Configuring the Default Runlevel
A runlevel is a state, or mode, defined by services that are meant to be run when this runlevel is selected. Seven numbered runlevels exist (indexed from 0):
| Runlevel | Description |
|---|---|
0 | Used to halt the system. This runlevel is reserved and cannot be changed. |
1 | Used to run in a single-user mode. This runlevel is reserved and cannot be changed. |
2 | Not used by default. You are free to define it yourself. |
3 | Used to run in a full multi-user mode with a command-line user interface. |
4 | Not used by default. You are free to define it yourself. |
5 | Used to run in a full multi-user mode with a graphical user interface. |
6 | Used to reboot the system. This runlevel is reserved and cannot be changed. |
To check in which runlevel you are operating, type the following:
~]$ runlevel
N 5
The
runlevel command displays previous and current runlevel. In this case it is number 5, which means the system is running in a full multi-user mode with a graphical user interface.
The default runlevel can be changed by modifying the
/etc/inittab file, which contains a line near the end of the file similar to the following:
id:5:initdefault:
To do so, edit this file as
root and change the number on this line to the desired value. The change will take effect the next time you reboot the system.
