Dieser Inhalt ist in der von Ihnen ausgewählten Sprache nicht verfügbar.
31.6. Setting Module Parameters
Like the kernel itself, modules can also take parameters that change their behavior. Most of the time, the default ones work well, but occasionally it is necessary or desirable to set custom parameters for a module. Because parameters cannot be dynamically set for a module that is already loaded into a running kernel, there are two different methods for setting them.
- Load a kernel module by running the
modprobecommand along with a list of customized parameters on the command line. If the module is already loaded, you need to first unload all its dependencies and the module itself using themodprobe -rcommand. This method allows you to run a kernel module with specific settings without making the changes persistent. See Section 31.6.1, “Loading a Customized Module - Temporary Changes” for more information. - Alternatively, specify a list of the customized parameters in an existing or newly-created file in the
/etc/modprobe.d/directory. This method ensures that the module customization is persistent by setting the specified parameters accordingly each time the module is loaded, such as after every reboot ormodprobecommand. See Section 31.6.2, “Loading a Customized Module - Persistent Changes” for more information.
31.6.1. Loading a Customized Module - Temporary Changes
Sometimes it is useful or necessary to run a kernel module temporarily with specific settings. To load a kernel module with customized parameters for the current system session, or until the module is reloaded with different parameters, run
modprobe in the following format as root:
~]# modprobe <module_name> [parameter=value]
where [parameter=value] represents a list of customized parameters available to that module. When loading a module with custom parameters on the command line, be aware of the following:
- You can enter multiple parameters and values by separating them with spaces.
- Some module parameters expect a list of comma-separated values as their argument. When entering the list of values, do not insert a space after each comma, or
modprobewill incorrectly interpret the values following spaces as additional parameters. - The
modprobecommand silently succeeds with an exit status of0if it successfully loads the module, or the module is already loaded into the kernel. Thus, you must ensure that the module is not already loaded before attempting to load it with custom parameters. Themodprobecommand does not automatically reload the module, or alert you that it is already loaded.
The following procedure illustrates the recommended steps to load a kernel module with custom parameters on the
e1000e module, which is the network driver for Intel PRO/1000 network adapters, as an example:
Procedure 31.1. Loading a Kernel Module with Custom Parameters
- Verify whether the module is not already loaded into the kernel by running the following command:
~]# lsmod|grep e1000e e1000e 236338 0 ptp 9614 1 e1000e
Note that the output of the command in this example indicates that thee1000emodule is already loaded into the kernel. It also shows that this module has one dependency, theptpmodule. - If the module is already loaded into the kernel, you must unload the module and all its dependencies before proceeding with the next step. See Section 31.4, “Unloading a Module” for instructions on how to safely unload it.
- Load the module and list all custom parameters after the module name. For example, if you wanted to load the Intel PRO/1000 network driver with the interrupt throttle rate set to 3000 interrupts per second for the first, second and third instances of the driver, and Energy Efficient Ethernet (EEE) turned on [5], you would run, as root:
~]#
modprobe e1000e InterruptThrottleRate=3000,3000,3000 EEE=1This example illustrates passing multiple values to a single parameter by separating them with commas and omitting any spaces between them.
[5]
Despite what the example might imply, Energy Efficient Ethernet is turned on by default in the
e1000e driver.
