Dieser Inhalt ist in der von Ihnen ausgewählten Sprache nicht verfügbar.
22.16.6. Adding a Manycast Client Address
To add a manycast client address, that is to say, to configure a multicast address to be used for
NTP
server discovery, make use of the manycastclient
command in the ntp.conf
file.
The
manycastclient
command takes the following form:
manycastclient
address
where address is an
IP
multicast address from which packets are to be received. The client will send a request to the address and select the best servers from the responses and ignore other servers. NTP
communication then uses unicast associations, as if the discovered NTP
servers were listed in ntp.conf
.
This command configures a system to act as an
NTP
client. Systems can be both client and server at the same time.