Este conteúdo não está disponível no idioma selecionado.
25.7. iSCSI
This section describes the iSCSI API and the
iscsiadm utility. Before using the iscsiadm utility, install the iscsi-initiator-utils package first by running yum install iscsi-initiator-utils.
In Red Hat Enterprise Linux 7, the iSCSI service is lazily started by default. If root is not on an iSCSI device or there are no nodes marked with
node.startup = automatic then the iSCSI service will not start until an iscsiadm command is run that requires iscsid or the iscsi kernel modules to be started. For example, running the discovery command iscsiadm -m discovery -t st -p ip:port will cause iscsiadm to start the iSCSI service.
To force the iscsid daemon to run and iSCSI kernel modules to load, run
systemctl start iscsid.service.
25.7.1. iSCSI API
To get information about running sessions, run:
# iscsiadm -m session -P 3
This command displays the session/device state, session ID (sid), some negotiated parameters, and the SCSI devices accessible through the session.
For shorter output (for example, to display only the sid-to-node mapping), run:
# iscsiadm -m session -P 0
or
# iscsiadm -m session
These commands print the list of running sessions with the format:
driver [sid] target_ip:port,target_portal_group_tag proper_target_name
Example 25.3. Output of the iscsisadm -m session Command
For example:
# iscsiadm -m session tcp [2] 10.15.84.19:3260,2 iqn.1992-08.com.netapp:sn.33615311 tcp [3] 10.15.85.19:3260,3 iqn.1992-08.com.netapp:sn.33615311
For more information about the iSCSI API, refer to
/usr/share/doc/iscsi-initiator-utils-version/README.
