Chapter 7. Integrating Red Hat Gluster Storage with Windows Active Directory

download PDF
In this chapter, the tasks necessary for integrating Red Hat Gluster Storage nodes into an existing Windows Active Directory domain are described. The following diagram describes the architecture of integrating Red Hat Gluster Storage with Windows Active Directory.
Active Directory Integration

Figure 7.1. Active Directory Integration

This section assumes that you have an active directory domain installed. Before we go ahead with the configuration details, following is a list of data along with examples that will be used in the sections ahead.
Table 7.1. 
InformationExample Value
DNS domain name /
NetBIOS domain nameADDOM
Name of administrative accountadministrator
Netbios name of the clusterRHS-SMB

7.1. Prerequisites

Before integration, the following steps have to be completed on an existing Red Hat Gluster Storage environment:
  • Name Resolution

    The Red Hat Gluster Storage nodes must be able to resolve names from the AD domain via DNS. To verify the same you can use the following command:

    where, is the AD domain and dc1 is the name of a domain controller.
    For example, the /etc/resolv.conf file in a static network configuration could look like this:
    nameserver #
    nameserver #
    This example assumes that both the domain controllers are also the DNS servers of the domain.
  • Kerberos Packages

    If you want to use the kerberos client utilities, like kinit and klist, then manually install the krb5-workstation using the following command:

    # yum -y install krb5-workstation
  • Synchronize Time Service

    It is essential that the time service on each Red Hat Gluster Storage node and the Windows Active Directory server are synchronized, else the Kerberos authentication may fail due to clock skew. In environments where time services are not reliable, the best practice is to configure the Red Hat Gluster Storage nodes to synchronize time from the Windows Server.

    On each Red Hat Storage node, edit the file /etc/ntp.conf so the time is synchronized from a known, reliable time service:
    # Enable writing of statistics records.
    #statistics clockstats cryptostats loopstats peerstats
    Activate the change on each Red Hat Gluster Storage node by stopping the ntp daemon, updating the time, then starting the ntp daemon. Verify the change on both servers using the following commands:
    # service ntpd stop
    # service ntpd start
  • Samba Packages

    Ensure to install the following Samba packages along with its dependencies:

    • CTDB
    • samba
    • samba-client
    • samba-winbind
    • samba-winbind-modules
Red Hat logoGithubRedditYoutubeTwitter


Try, buy, & sell


About Red Hat Documentation

We help Red Hat users innovate and achieve their goals with our products and services with content they can trust.

Making open source more inclusive

Red Hat is committed to replacing problematic language in our code, documentation, and web properties. For more details, see the Red Hat Blog.

About Red Hat

We deliver hardened solutions that make it easier for enterprises to work across platforms and environments, from the core datacenter to the network edge.

© 2024 Red Hat, Inc.