Parameters for creating a RAID0

You can create a RAID0 striped logical volume by using the lvcreate --type raid0[meta] --stripes _Stripes --stripesize StripeSizeVolumeGroup [PhysicalVolumePath] command.

The following table describes different parameters, which you can use while creating a RAID0 striped logical volume.

Table 1. Parameters for creating a RAID0 striped logical volume
Parameter Description

--type raid0[_meta]

Specifying raid0 creates a RAID0 volume without metadata volumes. Specifying raid0_meta creates a RAID0 volume with metadata volumes. Since RAID0 is non-resilient, it does not store any mirrored data blocks as RAID1/10 or calculate and store any parity blocks as RAID4/5/6 do. Therefore it does not need metadata volumes to keep state about resynchronization progress of mirrored or parity blocks. Metadata volumes become mandatory on a conversion from RAID0 to RAID4/5/6/10. Specifying raid0_meta preallocates those metadata volumes to prevent a respective allocation failure.

--stripes Stripes

Specifies the number of devices to spread the logical volume across.

--stripesize StripeSize

Specifies the size of each stripe in kilobytes. This is the amount of data that is written to one device before moving to the next device.

VolumeGroup

Specifies the volume group to use.

PhysicalVolumePath

Specifies the devices to use. If this is not specified, LVM will choose the number of devices specified by the Stripes option, one for each stripe.