Ce contenu n'est pas disponible dans la langue sélectionnée.
10.3. PAM and Administrative Credential Caching
A number of graphical administrative tools in Red Hat Enterprise Linux, such as the GNOME's
control-center
, provide users with elevated privileges for up to five minutes using the pam_timestamp.so
module. It is important to understand how this mechanism works, because a user who walks away from a terminal while pam_timestamp.so
is in effect leaves the machine open to manipulation by anyone with physical access to the console.
In the PAM timestamp scheme, the graphical administrative application prompts the user for the root password when it is launched. When the user has been authenticated, the
pam_timestamp.so
module creates a timestamp file. By default, this is created in the /var/run/sudo/
directory. If the timestamp file already exists, graphical administrative programs do not prompt for a password. Instead, the pam_timestamp.so
module freshens the timestamp file, reserving an extra five minutes of unchallenged administrative access for the user.
You can verify the actual state of the timestamp file by inspecting the file in the
/var/run/sudo/
user directory. For the desktop, the relevant file is unknown:root
. If it is present and its timestamp is less than five minutes old, the credentials are valid.
The existence of the timestamp file is indicated by an authentication icon, which appears in the notification area of the panel.
Figure 10.1. The Authentication Icon
10.3.1. Common pam_timestamp Directives
The
pam_timestamp.so
module provides these two interfaces:
auth
session
In addition, the following options are available for
pam_timestamp.so
:
timestamp_timeout
: specifies the validity period (in seconds) of the timestamp file, by default 300 (five minutes).timestampdir
: specifies in which directory the timestamp file is stored, by default/var/run/sudo/
.- You can also use
verbose
ordebug
for more detailed messages.
For example:
auth sufficient pam_timestamp.so timestamp_timeout=600 session optional pam_timestamp.so
For details on how to use and configure PAM's directives, refer to Section 10.2, “About PAM Configuration Files”. See also the
pam_timestamp(8)
man page and the pam.conf(5)
man page.
10.3.2. Removing the Timestamp File
Before abandoning a console where a PAM timestamp is active, it is recommended that the timestamp file be destroyed. To do this from a graphical environment, click the authentication icon on the panel. This causes a dialog box to appear. Click the
button to destroy the active timestamp file.
Figure 10.2. Dismiss Authentication Dialog
The PAM timestamp file has some important characteristics:
- If logged in to the system remotely using
ssh
, use the/sbin/pam_timestamp_check -k root
command to destroy the timestamp file. - Run the
/sbin/pam_timestamp_check -k root
command from the same terminal window where the privileged application was launched. - The logged in user who originally invoked the
pam_timestamp.so
module must be the user who runs the/sbin/pam_timestamp_check -k
command. Do not run this command as root. - Killing the credentials on the desktop without using theaction on the icon can be done with the
/sbin/pam_timestamp_check
command./sbin/pam_timestamp_check -k root </dev/null >/dev/null 2>/dev/null
Any other method only removes the credentials from the PTY where the command was run.
Refer to the
pam_timestamp_check
man page for more information about destroying the timestamp file using pam_timestamp_check
.