SupportoConsoleSviluppatoriInizia una provaContatti

Questo contenuto non è disponibile nella lingua selezionata.

32.5. Using sadump on Fujitsu PRIMEQUEST systems

On Fujitsu PRIMEQUEST systems, you can also enable the stand-alone dump (sadump) functionality provided by the hardware. This utility operates by combining kdump, which is a standard part of Red Hat Enterprise Linux, and the additional sadump BIOS-based function provided by Fujitsu.

Note

For the purpose of ensuring a dump is captured in the event of an unexpected reboot, Fujitsu recommend that sadump is always enabled on PRIMEQUEST hardware.
The sadump utility is usually invoked when a kdump cannot be processed because Red Hat Enterprise Linux has became unresponsive. These conditions can include:
  • Red Hat Enterprise Linux panic or hang before kdump starts
  • An error while kdump is working

How to use sadump

To use sadump, complete the following steps:
  1. Install the following packages according to the kernel version in use: 
    # yum install kernel-debuginfo kernel-debuginfo-common
  2. Configure UEFI for sadump
    For more details, see the FUJITSU Server PRIMEQUEST 2000 Series Installation Manual.
  3. Configure Red Hat Enterprise Linux for sadump
    For more details, see Section 32.5.1, “Configure Red Hat Enterprise Linux for sadump”.
  4. Start sadump
    For more details, see the FUJITSU Server PRIMEQUEST 2000 Series Installation Manual.
  5. Check the memory dump
    For more details, see Section 32.5.2, “Check the memory dump”.

32.5.1. Configure Red Hat Enterprise Linux for sadump

  1. Install and configure kdump as described in Section 32.1, “Installing the kdump Service” and Section 32.2, “Configuring the kdump Service”.
  2. Ensure that kdump starts as expected for sadump:
    1. Configure Red Hat Enterprise Linux to not reboot after a kernel panic:
      By default, Red Hat Enterprise Linux reboots automatically after a kernel panic, which prevents sadump to start. To avoid this behavior, configure the /etc/sysctl.conf file as follows: 
      kernel.panic=0
    2. Configure Red Hat Enterprise Linux to start kdump by Nonmaskable Interrupt (NMI):
      In the procedure of starting sadump, starting kdump by NMI is needed at first.
      Configure /etc/sysctl.conf as follows: 
      kernel.unknown_nmi_panic=1
  3. Ensure that kdump behaves correctly for sadump:
    1. Configure Red Hat Enterprise Linux to stop after kdump:
      By default, Red Hat Enterprise Linux reboots automatically when kdump fails, which prevents sadump to start. To avoid this behavior, configure the /etc/kdump.conf file as follows: 
      default halt
      or 
      default shell
    2. Configure Red Hat Enterprise Linux to start sadump:
      Configure /etc/kdump.conf to not block the System Management Interrupt (SMI) and thus to enable sadump to start: 
      blacklist kvm-intel
Red Hat logoGithubRedditYoutubeTwitter

Formazione

Prova, acquista e vendi

Community

Informazioni sulla documentazione di Red Hat

Aiutiamo gli utenti Red Hat a innovarsi e raggiungere i propri obiettivi con i nostri prodotti e servizi grazie a contenuti di cui possono fidarsi.

Rendiamo l’open source più inclusivo

Red Hat si impegna a sostituire il linguaggio problematico nel codice, nella documentazione e nelle proprietà web. Per maggiori dettagli, visita ilBlog di Red Hat.

Informazioni su Red Hat

Forniamo soluzioni consolidate che rendono più semplice per le aziende lavorare su piattaforme e ambienti diversi, dal datacenter centrale all'edge della rete.

© 2024 Red Hat, Inc.