Cellular 5G test
You can run the Cellular 5G test to certify that a 5G modem successfully establishes and maintains a data connection. You can also optionally evaluate network throughput.
- What the test covers
- The Cellular 5G test validates Global System for Mobile Communications (GSM) device detection and connection activation through
NetworkManager. It also validates network connectivity. You can optionally run theiperf3-based performance test after you configure a test server. - RHEL version supported
-
- RHEL 9
- RHEL 10
- What the test does
-
The test performs the following actions:
- Planning phase - The test detects all GSM devices through the
nmclidevice (type gsm) and creates a separate test instance for each detected modem. This enables independent testing of multiple cellular modems on the same system. - Detect GSM device - The test re-enables Universal Serial Bus (USB) devices and waits up to 100 seconds for the
ModemManagerservice to initialize and for the GSM modem to become available. - Enable GSM connection - The test creates and activates a GSM connection profile, Access Point Name (APN) internet, by using the
nmcliutility on thewwporwwaninterface. - Test GSM connection - The test verifies cellular data connectivity by pinging an external host over the cellular interface.
- Cellular performance test (optional) - If a test server is configured, the test runs an
iperf3throughput test for 30 seconds, reporting every 10 seconds, over the cellular connection. The test compares the bandwidth against 80% of the target speed for the 2 Gbps interface.
- Planning phase - The test detects all GSM devices through the
- Key differences from Cellular 4G
-
Attribute Cellular 4G Cellular 5G Supported generation
Long-Term Evolution (LTE)
5G New Radio (NR)
Interface speed target
1 Gbps
2 Gbps
- Preparing for the test
-
Ensure that the following requirements are met to prepare for the test:
- The system has a 5G NR-capable cellular modem.
- An active Subscriber Identity Module (SIM) card with a data plan is installed.
- The
NetworkManager-wwanRPM package is installed. - The
ModemManagerandNetworkManagerservices are enabled. - Optional: A test server is configured for
iperf3-based performance testing.
- Running the test
- Run the test by using the
rhcert-clitool. To enable the performance subtest, configure a test server. Theiperf3server is started and stopped automatically on the remote host.