memory_HBM
The memory_HBM tests evaluate the functionality of High Bandwidth Memory (HBM) on equipped systems. You can run these tests to verify that your system’s HBM operates correctly. This applies across different configurations, such as caching or flat memory modes.
- What the memory_HBM tests cover
- The memory_HBM tests are used to test system High Bandwidth Memory (HBM) on systems with it present. One of the three possible tests is planned based on the HBM operating mode. If the system HBM is not supported a regular memory test is planned instead.
- RHEL version supported
-
- RHEL 8
- RHEL 9
- RHEL 10
- What the tests do
- The memory_HBM tests are memory tests specifically for systems with HBM present.
- Preparing for the test
- Ensure that the system HBM meets the requirements specified in the Policy Guide.
- Running the test
-
- Run
rhcert-cli plan. One of the memory_HBM tests is planned if your HBM configuration meets the requirements and one of the following conditions:- memory_HBM_only: There is no DIMM installed in the system
- memory_HBM_cache: HBM acts as cache to the DIMM
- memory_HBM_flat: DIMM and HBM are available as a total amount of memory
- To run the test, use the command
rhcert-cli run --test. For example,rhcert-cli run --test hwcert/memory_HBM_cacheruns the memory_HBM_cache test. - Follow the instructions of the test.
- Use
rhcert-printto check the result. - To save the result use
rhcert-save.
- Run
- Run time
-
The memory_HBM tests typically complete within the same timeframe as standard memory certification tests for the configured HBM mode.