Execution paths
Select the column that matches your hardware’s relationship to the Phase 1 software certification.
| PATH A: UNTESTED For new or unknown hardware | PATH B: DIRECT LEVERAGE Exact hardware used in Phase 1 | PATH C: PASS-THROUGH Variant (Size, Brand, or Design) |
|---|---|---|
|
Create Request |
Create Request |
Create Request |
|
Storage Test Plan (Generated by Red Hat) |
Direct Test Plan (Generated by Red Hat) |
Hardware Relationship Review (Partner submits details to Red Hat) |
|
Run Active Tests (Partner runs full suite) |
Verify Software Certification (Red Hat verifies Phase 1 results) |
Pass-Through Test Plan (Generated by Red Hat) |
|
Verify Hardware Match (Red Hat confirms Identity) |
Verify Subsets & Credits (Red Hat confirms Variant logic) |
|
|
Verify Test Credits (Red Hat applies credits) |
Verify Test Credits (Red Hat applies credits) |
|
|
Run & Confirm (Partner confirms credits) |
Run & Confirm (Partner confirms credits) |
|
|
Submit & Review Results |
Submit & Review Results |
Submit & Review Results |
|
Publish |
Publish |
Publish |
Most certification subtests provide an immediate return status. The status is Pass or Fail. Some subtests require detailed review by Red Hat to confirm success or failure. Red Hat marks such tests with REVIEW status in the Red Hat Certification application.
Some tests identify a potential issue and return a WARN status. This status indicates that best practices were not followed. Tests marked with WARN status warrant attention or actions. They do not prevent a certification from publishing. Review the output of such tests and perform appropriate actions. Base your actions on the information contained within the warnings.
For information about certification prerequisites, see the Red Hat Storage Appliance Hardware Policy Guide.