Expresscard
The expresscard test evaluates your system’s interaction with ExpressCard devices. You can run the expresscard test to verify that your system successfully interacts with ExpressCard devices.
- What the test covers
- The expresscard test looks for devices with both types of ExpressCard interfaces, USB and PCI Express (PCIe). It confirms that the system can communicate through both interfaces. ExpressCard slot detection is not as straightforward as detecting other devices in the system. ExpressCard was specifically designed to not require any kind of dedicated bridge device. It’s merely a novel form factor interface that combines PCIe and USB. Because of this, there is no specific "ExpressCard slot" entry that we can see in the output of udev. We decided to schedule the test on systems that contain a battery, USB, and PCIe interfaces. We have seen no devices other than ExpressCard-containing laptops with this combination of hardware.
- RHEL version supported
-
- RHEL 8
- RHEL 9
- RHEL 10
- What the test does
- The test first takes a snapshot of all the devices on the USB and PCIe buses. It uses the lsusb and lspci commands to do this. It then asks the tester how many ExpressCard slots are present in the system. The tester is asked to insert a card in one of the slots. The system scans the USB and PCIe buses. It compares the results to the original lsusb and lspci output to detect any new devices. If a USB device is detected, the system asks you to remove the card. It then asks you to insert a card with a PCIe interface into the same slot. If a PCIe-based card is detected, the system asks you to remove it and insert a USB-based card into the same slot. If a card has both interfaces, such as a docking station card, it fulfills both testing requirements for the slot at once. This procedure is repeated for all slots in the system.
- Preparing for the test
- You need ExpressCard cards with USB and PCIe buses. This can be two separate cards or one card with both interfaces. Remove all ExpressCard cards before running the test.
- Running the test
-
The expresscard test is interactive. Run the following command and then select the appropriate
Expresscardtest name from the list that displays.rhcert-runIt prompts you to remove all ExpressCards. It then asks for permission to load the PCI Express hotplug module (pciehp), if it is not loaded. PCIe hotplug capabilities are needed to add or remove PCIe-based ExpressCard cards while the system is running. Next, the test asks you for the number of ExpressCard slots in the system. It then prompts you to insert and remove cards with both types of interfaces (USB and PCIe) in any order.