Questo contenuto non è disponibile nella lingua selezionata.
26.2.5. vsftpd Configuration Options
Although
vsftpd may not offer the level of customization other widely available FTP servers have, it offers enough options to fill most administrator's needs. The fact that it is not overly feature-laden limits configuration and programmatic errors.
All configuration of
vsftpd is handled by its configuration file, /etc/vsftpd/vsftpd.conf. Each directive is on its own line within the file and follows the following format:
<directive>=<value>
For each directive, replace <directive> with a valid directive and <value> with a valid value.
Important
There must not be any spaces between the <directive>, equal symbol, and the <value> in a directive.
Comment lines must be preceded by a hash mark (
#) and are ignored by the daemon.
For a complete list of all directives available, refer to the man page for
vsftpd.conf.
Important
For an overview of ways to secure
vsftpd, refer to Section 48.2, “Server Security”.
The following is a list of some of the more important directives within
/etc/vsftpd/vsftpd.conf. All directives not explicitly found within vsftpd's configuration file are set to their default value.
26.2.5.1. Daemon Options
The following is a list of directives which control the overall behavior of the
vsftpd daemon.
listen— When enabled,vsftpdruns in stand-alone mode. Red Hat Enterprise Linux sets this value toYES. This directive cannot be used in conjunction with thelisten_ipv6directive.The default value isNO.listen_ipv6— When enabled,vsftpdruns in stand-alone mode, but listens only to IPv6 sockets. This directive cannot be used in conjunction with thelistendirective.The default value isNO.session_support— When enabled,vsftpdattempts to maintain login sessions for each user through Pluggable Authentication Modules (PAM). Refer to Section 48.4, “Pluggable Authentication Modules (PAM)” for more information. If session logging is not necessary, disabling this option allowsvsftpdto run with less processes and lower privileges.The default value isYES.
