此内容没有您所选择的语言版本。
30.2. Preparing to Upgrade
Before upgrading the kernel, it is recommended that you take some precautionary steps.
First, ensure that working boot media exists for the system. If the boot loader is not configured properly to boot the new kernel, you can use this media to boot into Red Hat Enterprise Linux.
USB media often comes in the form of flash devices sometimes called pen drives, thumb disks, or keys, or as an externally-connected hard disk device. Almost all media of this type is formatted as a
VFAT file system. You can create bootable USB media on media formatted as ext2, ext3, or VFAT.
You can transfer a distribution image file or a minimal boot media image file to USB media. Make sure that sufficient free space is available on the device. Around
4 GB is required for a distribution DVD image, around 700 MB for a distribution CD image, or around 10 MB for a minimal boot media image.
You must have a copy of the
boot.iso file from a Red Hat Enterprise Linux installation DVD, or installation CD-ROM #1, and you need a USB storage device formatted with the VFAT file system and around 16 MB of free space. The following procedure will not affect existing files on the USB storage device unless they have the same path names as the files that you copy onto it. To create USB boot media, perform the following commands as root:
- Install the SYSLINUX boot loader on the USB storage device:
~]#
syslinux /dev/sdX1...where sdX is the device name. - Create mount points for
boot.isoand the USB storage device:~]#
mkdir /mnt/isoboot /mnt/diskboot - Mount
boot.iso:~]#
mount -o loop boot.iso /mnt/isoboot - Mount the USB storage device:
~]#
mount /dev/<sdX1> /mnt/diskboot - Copy the ISOLINUX files from the
boot.isoto the USB storage device:~]#
cp /mnt/isoboot/isolinux/* /mnt/diskboot - Use the
isolinux.cfgfile fromboot.isoas thesyslinux.cfgfile for the USB device:~]#
grep -v local /mnt/isoboot/isolinux/isolinux.cfg > /mnt/diskboot/syslinux.cfg - Unmount
boot.isoand the USB storage device:~]#
umount /mnt/isoboot /mnt/diskboot - You should reboot the machine with the boot media and verify that you are able to boot with it before continuing.
Alternatively, on systems with a floppy drive, you can create a boot diskette by installing the mkbootdisk package and running the
mkbootdisk command as root. See man mkbootdisk man page after installing the package for usage information.
To determine which kernel packages are installed, execute the command
yum list installed "kernel-*" at a shell prompt. The output will comprise some or all of the following packages, depending on the system's architecture, and the version numbers may differ:
~]# yum list installed "kernel-*"
kernel.x86_64 2.6.32-17.el6 @rhel-x86_64-server-6
kernel-doc.noarch 2.6.32-17.el6 @rhel-x86_64-server-6
kernel-firmware.noarch 2.6.32-17.el6 @rhel-x86_64-server-6
kernel-headers.x86_64 2.6.32-17.el6 @rhel-x86_64-server-6
From the output, determine which packages need to be downloaded for the kernel upgrade. For a single processor system, the only required package is the kernel package. See Section 30.1, “Overview of Kernel Packages” for descriptions of the different packages.
