此内容没有您所选择的语言版本。
6.3.2. Creating a New RAID Device
To create a new RAID device, use the command in the following form as
root:
mdadm--createraid_device--level=level--raid-devices=number component_device…
This is the simplest way to create a RAID array. There are many more options that allow you to specify the number of spare devices, the block size of a stripe array, if the array has a write-intent bitmap, and much more. All these options can have a significant impact on the performance, but are beyond the scope of this document. For more detailed information, refer to the CREATE MODE section of the
mdadm(8) manual page.
Example 6.2. Creating a new RAID device
Assume that the system has two unused SCSI disk drives available, and that each of these devices has exactly one partition of the same size:
~]# ls /dev/sd*
/dev/sda /dev/sda1 /dev/sdb /dev/sdb1
To create
/dev/md3 as a new RAID level 1 array from /dev/sda1 and /dev/sdb1, run the following command:
~]# mdadm --create /dev/md3 --level=1 --raid-devices=2 /dev/sda1 /dev/sdb1
mdadm: array /dev/md3 started.