11.10. Configuring automated enrollment of LUKS-encrypted volumes using Kickstart

Procédure

1. Instruct Kickstart to partition the disk such that LUKS encryption has enabled for all mount points, other than /boot, with a temporary password. The password is temporary for this step of the enrollment process.

   part /boot --fstype="xfs" --ondisk=vda --size=256
   part / --fstype="xfs" --ondisk=vda --grow --encrypted --passphrase=temppass

   Note that OSPP-compliant systems require a more complex configuration, for example:

   part /boot --fstype="xfs" --ondisk=vda --size=256
   part / --fstype="xfs" --ondisk=vda --size=2048 --encrypted --passphrase=temppass
   part /var --fstype="xfs" --ondisk=vda --size=1024 --encrypted --passphrase=temppass
   part /tmp --fstype="xfs" --ondisk=vda --size=1024 --encrypted --passphrase=temppass
   part /home --fstype="xfs" --ondisk=vda --size=2048 --grow --encrypted --passphrase=temppass
   part /var/log --fstype="xfs" --ondisk=vda --size=1024 --encrypted --passphrase=temppass
   part /var/log/audit --fstype="xfs" --ondisk=vda --size=1024 --encrypted --passphrase=temppass

2. Install the related Clevis packages by listing them in the %packages section:

   %packages
   clevis-dracut
   clevis-luks
   clevis-systemd
   %end

3. Optionally, to ensure that you can unlock the encrypted volume manually when required, add a strong passphrase before you remove the temporary passphrase. See the How to add a passphrase, key, or keyfile to an existing LUKS device article for more information.

4. Call clevis luks bind to perform binding in the %post section. Afterward, remove the temporary password:

   %post
   clevis luks bind -y -k - -d /dev/vda2 \
   tang '{"url":"http://tang.srv"}' <<< "temppass"
   cryptsetup luksRemoveKey /dev/vda2 <<< "temppass"
   dracut -fv --regenerate-all
   %end

   If your configuration relies on a Tang pin that requires network during early boot or you use NBDE clients with static IP configurations, you have to modify the dracut command as described in Configuring manual enrollment of LUKS-encrypted volumes.

   Note that the -y option for the clevis luks bind command is available from RHEL 8.3. In RHEL 8.2 and older, replace -y by -f in the clevis luks bind command and download the advertisement from the Tang server:

   %post
   curl -sfg http://tang.srv/adv -o adv.jws
   clevis luks bind -f -k - -d /dev/vda2 \
   tang '{"url":"http://tang.srv","adv":"adv.jws"}' <<< "temppass"
   cryptsetup luksRemoveKey /dev/vda2 <<< "temppass"
   dracut -fv --regenerate-all
   %end

   Avertissement

   The cryptsetup luksRemoveKey command prevents any further administration of a LUKS2 device on which you apply it. You can recover a removed master key using the dmsetup command only for LUKS1 devices.