검색

이 콘텐츠는 선택한 언어로 제공되지 않습니다.

8.2.3. Channel Bonding Interfaces

download PDF
Red Hat Enterprise Linux allows administrators to bind multiple network interfaces together into a single channel using the bonding kernel module and a special network interface called a channel bonding interface. Channel bonding enables two or more network interfaces to act as one, simultaneously increasing the bandwidth and providing redundancy.
To create a channel bonding interface, create a file in the /etc/sysconfig/network-scripts/ directory called ifcfg-bond<N>, replacing <N> with the number for the interface, such as 0.
The contents of the file can be identical to whatever type of interface that is getting bonded, such as an Ethernet interface. The only difference is that the DEVICE= directive must be bond<N>, replacing <N> with the number for the interface.
The following is a sample channel bonding configuration file:
DEVICE=bond0
BOOTPROTO=none
ONBOOT=yes
NETWORK=10.0.1.0
NETMASK=255.255.255.0
IPADDR=10.0.1.27
USERCTL=no
After the channel bonding interface is created, the network interfaces to be bound together must be configured by adding the MASTER= and SLAVE= directives to their configuration files. The configuration files for each of the channel bonded interfaces can be nearly identical.
For example, if channel bonding two Ethernet interfaces, both eth0 and eth1 may look like the following example:
DEVICE=eth<N>
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no
In this example, replace <N> with the numerical value for the interface.
For a channel bonding interface to be valid, the kernel module must be loaded. To insure that the module is loaded when the channel bonding interface is brought up, add the following line to /etc/modprobe.conf:
install bond0 /sbin/modprobe bonding -o bond0
Once /etc/modprobe.conf is configured, and the channel bonding interface and network interfaces are configured, the ifup command can be used to bring up the channel bonding interface.

Important

Important aspects of the channel bonding interface are controlled through the kernel module. For more information about controlling the bonding modules, refer to Section 22.5.2, “The Channel Bonding Module”.
Red Hat logoGithubRedditYoutubeTwitter

자세한 정보

평가판, 구매 및 판매

커뮤니티

Red Hat 문서 정보

Red Hat을 사용하는 고객은 신뢰할 수 있는 콘텐츠가 포함된 제품과 서비스를 통해 혁신하고 목표를 달성할 수 있습니다.

보다 포괄적 수용을 위한 오픈 소스 용어 교체

Red Hat은 코드, 문서, 웹 속성에서 문제가 있는 언어를 교체하기 위해 최선을 다하고 있습니다. 자세한 내용은 다음을 참조하세요.Red Hat 블로그.

Red Hat 소개

Red Hat은 기업이 핵심 데이터 센터에서 네트워크 에지에 이르기까지 플랫폼과 환경 전반에서 더 쉽게 작업할 수 있도록 강화된 솔루션을 제공합니다.

© 2024 Red Hat, Inc.