63.9. Global settings for test scenarios

You can use the global Settings tab on the right side of the test scenarios designer to set and modify the additional properties of assets.

Follow the procedure below to view and edit the global settings of rule-based test scenarios.

Procedure

Click Settings tab on the right side of the test scenario designer to display the attributes.
Configure the following attributes in the Settings panel:
- Name: You can change the name of the existing test scenarios by using the Rename option from the upper-right toolbar in the designer.
- Type: This attribute specifies it is a rule-based test scenario and it is read-only.
- Stateless Session: Select or clear this check box to specify if the KieSession is stateless or not.
  注記
  If the current KieSession is stateless and the check box is not selected, the tests will fail.
- KieSession: (Optional) Enter the KieSession for the test scenario.
- RuleFlowGroup/AgendaGroup: (Optional) Enter the RuleFlowGroup or AgendaGroup for the test scenario.
Optional: To skip the entire simulation from project level after test execution, select the check box.
Click Save.