25.9. Configuring a default automember group using IdM CLI
When you configure a default automember group, new user or host entries that do not match any automember rule are automatically added to this default group.
Prerequisites
- You must be logged in as the administrator. For details, see Using kinit to log in to IdM manually.
- The target group you want to set as default exists in IdM.
Procedure
-
Enter the
ipa automember-default-group-setcommand to configure a default automember group. When prompted, specify:
- Default (fallback) Group, which specifies the target group name.
Grouping Type, which specifies whether the target is a user group or a host group. To target a user group, enter group. To target a host group, enter hostgroup.
For example:
$ ipa automember-default-group-set Default (fallback) Group: default_user_group Grouping Type: group --------------------------------------------------- Set default (fallback) group for automember "default_user_group" --------------------------------------------------- Default (fallback) Group: cn=default_user_group,cn=groups,cn=accounts,dc=example,dc=com
참고To remove the current default automember group, enter the
ipa automember-default-group-removecommand.
Verification
To verify that the group is set correctly, enter the
ipa automember-default-group-showcommand. The command displays the current default automember group. For example:$ ipa automember-default-group-show Grouping Type: group Default (fallback) Group: cn=default_user_group,cn=groups,cn=accounts,dc=example,dc=com